Hunter Ceiling Fan Light Goes Off and Wont Turn on Again

Troubleshooting a Hunter Ceiling Fan

Hunter ceiling fans are known and trusted worldwide for their reliability. On the rare occasion at that place is a problem it can come up as a bit of a daze especially every bit it usually happens after a catamenia of non-use through the winter once the weather starts to warm up.

Hunter Ceiling Fan Motor Cross Section

Normally in one case the fan is installed you can wait forrard to years of performance and really non give information technology a lot of thought till there is a problem. Every twenty-four hours our Technical Back up Department gets questions from people all over the Globe who take purchased a Hunter ceiling fan and are encountering various technical issues.  All of the issues listed below are hands rectified and depend on the age of the fan.  It is always essential when contacting our Technical Support Department to be able to united states of america the exact model name and approximate age of the fan.

We manage to resolve 95% of issues very rapidly and nosotros stock a wide range of spares and replacements to ensure resolution.  In the rare occasion that nosotros cannot get your fan fixed and a replacement nether the Lifetime Warranty is required so we can organise a complete fan replacement for you.  If your model is very old and obsolete then we will replace information technology with the nearest current equivalent model.   We can merely do this for fans purchased from usa so if you bought it cheap off ebay from some overseas company then get back to them for a replacement if they still exist.  We are still happy to assist and sell you spares on a all-time endeavours basis simply nosotros cannot guarantee a resolution.

Hunter Ceiling Fan Replacement Capacitor and Wiring Harness

Top 6 Technical Faults For A Ceiling Fan

Here nosotros list the tiptop 6 well-nigh frequent technical faults that we come across.  We don't include here replacements of typical parts like the pull concatenation or on/off switch.

1.  The fan of a sudden stops working or on installation does not piece of work
Probably causes for this are the remote control handset or receiver, the wall command, incorrect installation (wiring the fan upwardly incorrectly), a broken switch or capacitor (if the fan was working previously).

2.  The lite has stopped working or on installation does non work
Probably causes are a faulty lite kit, the fuse in the low-cal kit has blown, a faulty wall or remote command which could be either the handset or receiver, cleaved or faulty calorie-free switch or just incorrect installation.

three. The fan or low-cal functions on its own accord randomly
Probably acquired by the receiver for the remote control indicate which sits in the fan mounting canopy which is getting interference from another source in the same room or close by.  Manufacturers typically use the same set up of RF frequencies for different consumer products and then for example a new Howdy Fi arrangement or Telly could trigger this or even just rearranging items in the room.  The way to fix it is to modify the RF channel on the receiver (normally past a dip switch) and also in the handset – there are 16 channels to choose from.  NB: Ensure that both the handset and the receiver are using the same channel or it volition non piece of work!

Hunter Ceiling Fan Replacement Hanging Kit

4. The Fan Speed Suffers Failures
This is where not all the speeds are performance as they should. Possible causes are poor installation, a capacitor fault or failure, and incorrect setting-upwardly of the wall or remote control receiver.

5. The fan makes a humming racket
In that location are a variety of reasons for this i merely information technology is usually due to a screw tightening issue. It tin be as simple as a single spiral needing simply i/8 of a turn. This could exist a blade to blade iron spiral, a blade iron to fan spiral or even a fan housing screw. Another possible cause is when a fan is wired to a dimmer switch.  If the dissonance is more than like a buzz so information technology could be a capacitor that has failed although this is rare every bit Hunter utilise very high quality capacitors.  If the fan is really former then it could also exist motor laminates breaking down.

half-dozen. The fan is wobbling
There should be no wobble at all if your fan is correctly installed.  Wobbling creates abrasive noises and can be eliminated either past choosing a fan that has the trilobular mounting system which automatically balances itself or by a elementary balancing procedure.  To balance the fan first try swapping the blades over to see if it fixes the problem.  If not

Hunter Ceiling Fan Replacement Light Switchthen apply the balancing kit that comes with the fan to put a small weight on one of the blades.  A scrap of trial and error should readily set up this issue.  We sell balancing kits separately if y'all have lost yours. Those are the six most common problems many of which are historic period dependent just all very piece of cake to resolve and go your Hunter Fan operating again.  Become to our back up page for further valuable information or for Hunter ceiling fan spares.

eliasfroasur.blogspot.com

Source: https://www.henleyfan.com/top-6-technical-faults-with-a-hunter-fan/

Share this post